Description
This kit contains everything needed to prepare your car for running RallySafe at an event. To purchase the kit, simply select from each of the options above and then add the kit to your cart. All parts are required. Instructions for installation are provided on the competitors page. RallySafe unit shown for illustration purposes only. Video guide available below:
Details of kit parts:
12v Wiring Loom: The wiring loom is the main power source for the Rally Safe unit, the wiring loom must be connected to a permanent power 12v source so the Rally Safe unit can function properly. The wiring loom comes in 3m & 5m lengths but can be shortened to the correct length.
3-in-1 Temporary Antenna with Wiring Loom: The 3-in-1 Temporary Antenna has 3 main aerial components that the RallySafe unit uses. 3-in-1 Temporary Antenna has all 3 leads running out the end of the antenna to then be ran along the roof, this allows the antenna leads to run through a door seal and into the vehicle cabin. This antenna is only recommended to temporary installs as the exposed wires increase the chance of damage in an accident or poor installation.
Please Note: 3-in-1 Permanent Antenna should be used for all permanent installs, Temporary antennas may result in antenna failure due external lead exposure.
Mount: There are two types of mounts. The most common is the Roll Cage Mount, which will fit any competitor vehicle with a roll cage installed. This mount clamps onto a round bar using a hose camp. Secondly there is the Flat Bolt On Mount that can be bolted to most flat surfaces. Both mounts have a 25mm rubber coated ball to fit the appropriate 25mm Mount Connector.
Mount Connector: This connects to mount to the RallySafe unit. This is done using the ball on the mount and the ball on the back of the RallySafe unit. Available in 50mm & 75mm lengths.
If you have any questions, please consult our competitors page, or contact us.
